Plastikote Sealers.. Need Help Urgent

[C2567]

I have a little problem, I'm hoping Someone can help me.. please..
I bought three sealers Hi-gloss, matt and satin Of the Brand Plastikote
The Hi-gloss Works fine, its very nice. but the matt and satin dont work! As I spray, Along with the sealer some white blobs (Not very opaque blobs) stick on to the figure, It says to shake for 1 minute and trust me I shook these suckers hard! My arm was vibrating for a whole minute after! but its still like that. the matt is the worst, it totally ruins any figure.

I cant buy Krylon as its not available in any Online store in the UK. I cant use eBay as well. Please help I really need the matt sealer for sideways!

[C2567]

hellooo? Nobody going to help me?

[BigHank]

I belive in the UK you should be able to find Humbrol brand at the hobbystore. I've seen others use the matte clear with outstanding results. I have not, however , tried it myself. Hope that info can help you out a bit!

[- Z -]

Clean the spray nozzle...... sound like you have a clog that is spitting oout clumps. Also try putting the spray can in a bath of warm water for a few minutes before spraying.

[Hatchet]

Testors Dulcote might be available. It works pretty well.

Good luck man, hope everything works out.

[C2567]

I belive in the UK you should be able to find Humbrol brand at the hobbystore. I've seen others use the matte clear with outstanding results. I have not, however , tried it myself. Hope that info can help you out a bit!

Humbrol, I'm familiar with the brand, Ok I'll check it out! Thanks!

Clean the spray nozzle...... sound like you have a clog that is spitting oout clumps. Also try putting the spray can in a bath of warm water for a few minutes before spraying

Thanks I'll try this! If it doesnt work, I'll consider the Humbrol

Testors Dulcote might be available. It works pretty well.

Good luck man, hope everything works out

Thanks! I hope so too.